|Install:||Magnets And Screw Mount||Light Sensor:||Yes|
|Bands:||Global Connectivity||Battery:||Lithium Ion|
CATM1 battery powered tracking device,
2G battery powered tracking device,
2G 5g gps tracker
NT07ES is Lte - M CATM1 NB- IOT 2G 5G Screw Mount Non-powered long battery life GPS Assets Tracker , the device GPS and Wifi chip for indoors and outdoors tracking, the device comes with a screw mount to better fit on the objects surface.
1. Magnets and screw mount
2. No wires, easy for installation
3. Indoors tracking
5. Motion alarm
6. Temperature monitor
7. IP67 waterproof
8. AGPS, WIFI,LBS,WIFI
|Cellular||Communication module||Quectel BG95 M3|
• Cat M1: LTE-FDD B1/B2/B3/B4/B5/B8/B12/B13/B14/B18/B19/B20/B25/B26*/B27/B28/B66/B85
Accuracy: 5m CEP
Cold start: <27s
Hot start: <1s
Disposable Lithium-ion battery and (3.6V,5400Mah or 8100mAh)
and ultra-low discharge rate:less than 1%, store one year below 25℃
|Power consumption||Average working current <100mA; Power save current <7uA;|
|GSM antenna||Internal High Gain|
|GPS antenna||Internal High Gain|
|Indicator||2 status LEDs, Green: GPS, Red:Celluar|
|Environmental Parameter||Working Temperature||-20℃ ~ +70℃|
|Humidity||5% ~ 95% (no fog)|
|Ingress Protection Rating||IP67|
• Wifi Locate
The device has built in Wi-Fi Chip, it automatically connects to the WIFI hotspot nearby and filter the hotspot info then select the WIFI hotspots with strongest signal, the device will pack those hotspots info and saved into the packet that will be uploaded, after the backend receives Wi-Fi information, it will interpret the WIFI info and acquire the current location from the Wi-Fi database, The default setting is WIFI priority, once it detects WIFI Hotspot, it will upload WIFI info only , and do not use GPS, if WIFI is not detected, it will use GPS to position.
The default position mode is by GPS, however when device enters into the blind zone and GPS cannot be fixed, the device will switch to LBS position, LBS provides the reference location which is might not accurate
• OTA commands from backend
Since the wake up of the device is short, it is hardly to receive SMS , to ensure the command sending efficiently, we suggest an OTA commands to be sent from the platform, when the device is online, the backend will automatic send this command, to make sure the commands is properly received.
The default setting is upload once a day, the upload packet information includes: Position status, longitude and latitude, network signal Strength, satellite numbers, battery voltage etc, the upload interval can be configured either by SMS or through tracking platform software
Q1. Can you help for design?
A:Yes,we have our own software and hardware engineer,you can give your idea to us,we can assist the design work.Provide sample for your reference.
Contact Person: Ava Tian